Neptune suction

The Neptune suction device is used for surgical procedures in the Cath Lab for both fluid management and smoke evacuation.

Key information

• The Neptune lives behind EP. If it is unavailable, a second device can usually be borrowed from the OR.
• When finished with the unit, it needs to be emptied. See the Cleaning section below.
• The Neptune is extremely powerful. Use the lowest possible suction setting to do the job.

Setup

• Position the device where needed.
• Plug in and insert filter into top (smaller < 4L capacity), or bottom (larger ~20L capacity) tank port.
• Connect suction tubing to filter, activate suction, and adjust suction level as needed.
• Smoke evacuation port is located on side of device, it activates automatically.

Cleaning

• Turn off device, unplug, and wipe down exterior.
• If not needed immediately for another case, or if full, take unit to the workroom next to OR room 1.
• Roll unit into dock and follow instructions on screen (very simple).
• If another unit is there and busy, take the dirty unit to the main workroom where the dirty OR elevator is located.
• if there is a clean unit in place, you can take it as replacement for the dirty one.
• Unit must not be returned to EP dirty!!!