Mitral Clip: Difference between revisions
From Bay Area Structural Heart Wiki
No edit summary |
No edit summary |
||
| Line 9: | Line 9: | ||
|- | |- | ||
|General | |General | ||
|Fluoro, TEE | |Fluoro, TEE | ||
| | | | ||
Femoral Vein | Femoral Vein | ||
| Line 27: | Line 27: | ||
*Clear Plexiglass base support | *Clear Plexiglass base support | ||
*Sterile System Stabilizer | *Sterile System Stabilizer | ||
*Baylis generator | *Baylis generator | ||
**9fr x 23cm Pinnacle for ICE | **9fr x 23cm Pinnacle for ICE | ||
===Baylis/transseptal:=== | ===Baylis/transseptal:=== | ||
====Open==== | ====Open==== | ||
| Line 52: | Line 50: | ||
====Open==== | ====Open==== | ||
*5F MPA2 | *5F MPA2 | ||
===Misc supplies:=== | ===Misc supplies:=== | ||
| Line 67: | Line 65: | ||
*12” extension (Keep stickers to label flush tubing) | *12” extension (Keep stickers to label flush tubing) | ||
*Sterile towel pack for back table | *Sterile towel pack for back table | ||
*3 port manifold to measure LA pressure only | *3 port manifold to measure LA pressure only | ||
*Fluoro cover to anesthesia IV pole or moving xray shield | *Fluoro cover to anesthesia IV pole or moving xray shield | ||
*20F Dilator | *20F Dilator | ||
| Line 109: | Line 107: | ||
*LA pressure measured. Set up for subsequent clips if needed. | *LA pressure measured. Set up for subsequent clips if needed. | ||
*Vicryl used for groin closure. | *Vicryl used for groin closure. | ||
==BACK TABLE SETUP== | ==BACK TABLE SETUP== | ||
Revision as of 21:38, 22 June 2020
DRAFT
| Mitral Clip | |||||
|---|---|---|---|---|---|
| Anesthesia | Imaging | Access | Pre-Procedure | ||
| General | Fluoro, TEE |
Femoral Vein |
|||
The Tricuspid clip now has its own page at Tricuspid Clip
Procedural Gems:
- When using the PDOII plug In MitraClip setting use TorqView 180 (smaller cable needed)
Big Equipment:
Open
- Cath pack
- Lift / Footstool / Support base
- Clear Plexiglass base support
- Sterile System Stabilizer
- Baylis generator
- 9fr x 23cm Pinnacle for ICE
Baylis/transseptal:
Open
- SL1 TransSeptal sheath
- Large curve Baylis needle
- Baylis cable
- Grounding pad
Wires:
Open
- .032 X 260 “J” wire
- Amplatz SuperStiff 1cm Tip
- 150J
Catheters:
Open
- 5F MPA2
Misc supplies:
Open
- (2) 108cm High pressure IV Lines
- (5) Stopcocks
- 8F Sheath for dilator - (also used as a backup sheath)
- (1)Perclose
- 4-0 Vicryl/monocryl
- Pickups (Either from a suture removal kit or individual from SPD)
- (2) 60cc syringe
- 12” extension (Keep stickers to label flush tubing)
- Sterile towel pack for back table
- 3 port manifold to measure LA pressure only
- Fluoro cover to anesthesia IV pole or moving xray shield
- 20F Dilator
- Micropuncture
- U/S probe cover
Standby
- 20fr. DrySeal for recovering wire to LUPV
- Additional Perclose
- Pericardiocentesis supplies
Non-Sterile Supplies
- (2) Liter bags of heparinized saline
- (2) Liter sized pressure bags
Procedure
- Anesthesia will obtain radial art line prior to draping.
- Pre procedure TEE imaging performed
- Prior to prepping patient, place MitraClip Plate (plexiglass board – hinge side up) under patient’s leg off center to the right. Place MitralClip Lift (step stool) over patients right leg, angled down towards the head. Measure 75cm from subxyphoid to leading edge of stool. Make sure there is direct contact between stool and plate.
- Prep patient and drape per usual. Drape anesthesia pole and/or xray shield.
- Obtain RFV access, dilate with 8F, preclose. .032 wire inserted into perclose.
- SL1 introduced over .032 wire.
- Baylis needle inserted and echo imaging performed. Transseptal puncture performed.
- Baylis needle removed. .032wire inserted. Dilator removed
- MPA advanced over the wire to pulmonary vein. LA pressure measured. Give MD Amplatz SuperStiff to shape.
- Amplatz SuperStiff advanced.
- MPA removed.
- SL1 removed
- 20F dilator inserted and removed
- MitraClip Guide inserted.
- Setup stabilizer and silicone sheet. Hand MD 60ml syringe with short extension tubing for aspiration.
- Amplatz wire and dilator removed. Clip inserted.
- Drips should be maintained at 1 drip every 3 seconds. If bubbles are seen on echo, turn drips down.
- When clip is being deployed turn room lights up and drips up. Place bowl below to catch drips while deploying.
- Hand MD 60ml syringe with extension tubing for aspiration while delivery system is removed.
- LA pressure measured. Set up for subsequent clips if needed.
- Vicryl used for groin closure.
BACK TABLE SETUP
- 108" Tubing spikes handed off to circulator, keep rollers on sterile field.
- Follow Rep instructions for device prep.
APPROVED: MD initials MM/YY
