Cryo Setup

Cryo Equipment/Supplies

• Cryo Console (Located in sterile core)
• Cryo Catheter (4,6,or 8mm)
• Electrical Umbilical (Sterile core)
• Coaxial Umbilical (Sterile core)

Steps

• Get cryo console and position towards the foot of table on scrub side
• Connect Scavenging Hose (white hose on console) to vacuum port on boom near anesthesia
• Plug in power cable
• Open refrigerant tank in console (Lefty Loosey)
• Power up console (It is recommended that power is on at least 15mins prior to starting procedure)
• Check for error messages (If yes, check all connections and refrigerant tank is open and full. Reboot)
• After power up - Complete patient info screen
• Connect Auto-connection box (located inside the console) to the front of the console
• Plug pin connector box (located in room at bottom of 3rd cabinet) into 20pole B
• Connect Auto connection box pins in 20pole B 1 through 4 (Distal to Proximal)
• Connect Electrical Umbilical to Auto connection box (From sterile table to ACB)
• Connect Coaxial Umbilical to front of Console (From Sterile table to Console)
• Connect Catheter to Electrical and coaxial umbilicals
• Ensure appropriate signal routing on Prucka

Misc error codes:

-Message 50005

1) Ablation generator has not been powered off

2) Distal pin has not been disconnected prior to freeze

3) Blood in Cryo catheter