Rotablator: Difference between revisions
From Bay Area Structural Heart Wiki
No edit summary |
No edit summary |
||
Line 13: | Line 13: | ||
===Circulator=== | ===Circulator=== | ||
#Attach air hose to back of device | #Attach air hose to back of device. | ||
#Open nitrogen tank valve | #Open nitrogen tank valve. | ||
#Adjust regulator to appropriate pressure range ( | #Note tank pressure. (If below 1000, consider replacement) | ||
#Adjust regulator to appropriate pressure range (90-110 psi) using adjustment valve. | |||
**Adjust slowly using arrows on knob as a guide. | |||
**Pressure will not go down as you turn it down unless you vent the hose. | |||
**Vent hose by partially removing it from regulator. | |||
<br /> | <br /> | ||
[[Category:Product]] | [[Category:Product]] |
Revision as of 17:15, 7 April 2020
aka RotaPro
Manufacturer: Boston Scientific
Product website: BSC RotaPro
Setup
The RotaPro is kept behind Room 6. You need the IV pole with the device, the nitrogen tank, and the appropriate burr.
Open the burr for the scrub person to setup.
Circulator
- Attach air hose to back of device.
- Open nitrogen tank valve.
- Note tank pressure. (If below 1000, consider replacement)
- Adjust regulator to appropriate pressure range (90-110 psi) using adjustment valve.
- Adjust slowly using arrows on knob as a guide.
- Pressure will not go down as you turn it down unless you vent the hose.
- Vent hose by partially removing it from regulator.