Laser CVX-300

PHILIPS CVX-300 QUICK-START CHECKLIST

SET-UP

• Plug in CVX-300 and Turn Power Switch ON System will Complete Self-Test (5 minute warm up) (An audible beep will sound indicating the laser system is ready)
• Connect Foot Pedal

OPERATION

• Insert Catheter and Calibrate
  • Depress the Calibrate button, aim the catheter and 1-2 inches away from the energy detector
  • Depress the foot switch until the system completes calibration approximately 5 seconds) -The "Calibration Complete" or Cal OK" lamp is displayed
• Set the Fluence and Rate Per Physician's Instructions (i.e. 50/50)
• Select the "Ready" Mode
  • Depress foot pedal per Physician's instructions until lesion(s) modification is complete.
• Select "Standby" Mode when the laser i or is removed from body.

REPORTING

• Record "Pulses Delivered" in log book
  • Depressing the "Pulses Delivered" button enables the total number of pulses during a procedure to be visible in the display window Record "Treatment Time" in log book
  • Depressing the "Treatment Time" button enables the total lasing time of the procedure to be visible in the display window

TROUBLESHOOTING

• Laser System Will Not Turn ON
  • Verify power cord connections
  • Verify interlock plug installed
  • Verify main circuit breaker is in ON position
• Laser Buzzes When Plugged In
  • Release red emergency button
• Fault Codes 1-4, "Service", "Service Laser Soon", "Power Error"
  • Shut machine OFF, wait 30 seconds, then Turn ON
  • Call PHILIPS Customer Service @ 800-231-0978 for assistance

SHUTDOWN/STORAGE

• Turn the Laser System OFF
  • Disconnect and store the power cord
  • Disconnect and store the footswitch
  • Close the catheter connector door
  • Clean the energy detector's face with alcohol prep
  • Cover the laser system with the dust cover